Industrial Extension Ladders

Two Section Aluminum Ladders

Our most popular Industrial Extension Ladder.
Full width design for the industrial and contracting user.
A minimum of deflection and built-in side sway stability.
Deeper section BOX GIRDER side rails used in longer length ladders.
Corrugated round rungs.
Plated spring loaded rung locks.
Equipped with pulley and rope.
Slip resistant end plugs used on all side rails.
Easily separated to use base as a single section.
Fly section is not designed for separate use.
Available with parallel side rails - Model IP - or with flared base - Model IF - for additional stability.
Meets or exceeds applicable load and design requirements as specified by ANSI and recommended by OSHA.

MODEL IP & IF INDUSTRIAL 2-SECTION EXTENSIONS Type 1 Industrial Ladder - 250 lb. Rated
Length Model #	A"	B"	C'	D'	E"	F"	G"	Wt.
-16-2	2-1/2	1	13	8	16	19	23	32
-20-2	2-1/2	1	17	10	16	19	24	38
-24-2	2-1/2	1	21	12	16	19	25	43
-28-2	2-1/2	1	25	14	16	19	25	50
-32-2	3-1/8	1	29	16	16	19	27	66
-36-2	3-1/8	1	32	18	16	19	27	71
-40-2	3-1/8	1	35	20	16	19	27	79

Meets or exceeds applicable load and design requirements as specified by ANSI and recommended by OSHA.

Preferred by many for the shorter per section length.
More easily transported and stored
These industrial three section ladders are full width design and extremely rigid.
Same design, equipment, etc. as our two section industrial ladders.
Meets or exceeds applicable load and design requirements as specified by ANSI and recommended by OSHA.

MODEL IP & IF INDUSTRIAL 3-SECTION EXTENSIONS Type 1 Industrial Ladder - 250 lb. Rated
Length Model #	A"	B"	C'	D'	E"	F"	G"	H"	Wt.
-30-3	3-1/8	1	24	10	16	19	22	26	57
-36-3	3-1/8	1	28	12	16	19	22	27	68
42-3	3-1/8	1	32	14	16	19	22	27	80
48-3	3-1/8	1	38	16	16	19	22	27	95

Available for all Metallic extension, single, and sectional ladders.